196
D Flash Photography
If the camera is used with a flash unit or flash accessory dedicated to
another camera brand, the camera may not operate properly and
malfunction may result.
Do not connect to the camera’s PC terminal any flash unit requiring 250
V or more.
Do not attach a high-voltage flash unit on the camera’s hot shoe. It may
not fire.
A flash unit attached to the camera’s hot shoe and a flash unit connected to
the PC terminal can both be used at the same time.
Metered Manual Flash Exposure
This function is for close-up flash photography when you want to set the
flash level manually. Use an 18% gray card and an EX-series Speedlite with
manual flash mode. Follow the instructions below:
1. Set the camera and Speedlite settings.
• Set the camera’s shooting mode to <a> or <f>.
• Set the Speedlite to manual flash mode.
2. Focus the subject.
• Focus manually.
3. Set up the 18% gray card.
• Place the gray card at the subject’s position.
• In the viewfinder, the entire spot metering circle should cover the gray
card.
4. Press the <B> button. (8)
5. Set the flash exposure level.
• Adjust the Speedlite’s manual flash level and the camera
aperture so that the flash exposure level aligns with the
standard exposure index.
6. Take the picture.
• Remove the gray card and take the picture.
To Next Page
Loading...
