Staple Finisher-F1 PRO/Booklet Finisher-F1 PRO/Puncher Unit-BB1/Booklet Trimmer-D1 (Optional)
1-37
1
Routine Maintenance
Removing Punch Waste
When the punch waste tray of the Puncher Unit-BB1 becomes full, a screen similar to the one shown below appears on the touch
panel display. Follow the procedure described below to remove the punch waste.
Take care when handling the optional equipment that is attached to the machine. When an optional unit’s cover is opened to replace a staple
cartridge, discard the punch waste, or clear paper or staple jams, prints may still be output if other optional units are operating normally, and
are not involved in the paper or staple jam removal procedure.
• This procedure is necessary only if the Puncher Unit-BB1 is attached.
• When the punch waste tray is full, you cannot make copies or prints using the Hole Punch mode.
1
Open the front cover of the finisher.
2
Pull out the punch waste tray.
To Next Page
Loading...
Need help?
General
