support Camera
Direct Printing.
Automatic
double-sided
printing cannot
be performed.
[1310] --- This paper is not
compatible with two-
sided printing.
Remove the paper and
press [OK].
The paper length is not
supported for double-sided
printing.
Press the OK button to
eject the paper being used
at error occurrence.
Data which was to be
printed on the back side of
paper at error occurrence is
skipped (not printed).
- Duplex paper feed
roller unit
- PE sensor board ass'y
Failed in
automatic print
head alignment.
[2500] --- Auto head align has
failed. Press [OK] and
repeat operation. <See
manual>
Press the OK button to
clear the error, then
perform the automatic
print head alignment again.
(Use Matte Photo Paper
MP-101.)
If the alignment pattern
was not printed properly
(faint printing, etc.),
perform print head
cleaning, then perform the
print head alignment
again.
- Carriage unit
- Print head
- Purge drive system
unit
The remaining
ink amount
unknown (raw
ink present).
[1683] U130 The remaining level
of the ink cannot be
correctly detected.
Replace the ink tank.
An ink tank which has
once been empty is
installed. Replace the
applicable ink tank with a
new one. Printing with a
once-empty ink tank can
damage the machine.
To continue printing
without replacing the ink
tank(s), press the Stop
button for 5 sec. or longer
to disable the function to
detect the remaining ink
amount. After the
operation, it is recorded in
the machine EEPROM that
the function to detect the
remaining ink amount was
disabled.
- Ink tank
- Spur unit
Ink tank not
recognized.
[1684] U140 The following ink
tank cannot be
recognized.
An incompatible ink tank
is installed (the ink tank
LED is turned off). Install
- Ink tank
To Next Page
Loading...
