failed.
##281 TX Re-transmission of the procedure signal has been
attempted the specified number of times, but
failed.
- Try a higher transmission level.
##282 TX Re-transmission of the procedure signal has been
attempted the specified number of times, but
failed.
- Try a higher transmission level.
##283 TX Re-transmission of the procedure signal has been
attempted the specified number of times, but
failed.
- Try a higher transmission level.
##284 TX After TCF transmission, DCN has been received. - Set the receiving machine ready for
reception.
##285 TX After EOP transmission, DCN has been received. - Re-send the fax.
##286 TX After EOM transmission, DCN has been
received.
- Re-send the fax.
##287 TX After MPS transmission, DCN has been received. - Re-send the fax.
##288 TX After EOP transmission, a signal other than PIN,
PIP, MCF, RTP, RTN has been received.
##289 TX After EOM transmission, a signal other than PIN,
PIP, MCF, RTP, RTN has been received.
##290 TX After MPS transmission, a signal other than PIN,
PIP, MCF, RTP, RTN has been received.
##670 TX In V.8 late start, the DIS V.8 ability from the
receiving machine was detected, and CI was sent
in response; however, the procedure failed,
causing T1 time-over.
- In bit 0 of the service data #1 SSSW
SW28, prohibit the V.8 / V.34
procedure of the sending machine.
##671 RX In V.8 call reception, the procedure fails to
proceed to phase 2 after CM detection, causing
T1 time-over.
- In bit 0 of the service data #1 SSSW
SW28, prohibit the V.8 / V.34
procedure of the sending machine.
##672 TX In V.34 transmission, the procedure fails to
proceed from phase 2 to phase 3 or later, causing
T1 time-over
- In bit 0 of the service data #1 SSSW
SW28, prohibit the V.8 / V.34
procedure of the sending machine.
##673 RX In V.34 reception, the procedure fails to proceed
from phase 2 to phase 3 or later, causing T1 time-
over
- In bit 0 of the service data #1 SSSW
SW28, prohibit the V.8 / V.34
procedure of the sending machine.
##674 TX In V.34 transmission, the procedure fails to
proceed from phase 3 or 4 to the control channel
or later, causing T1 time-over
- In bit 0 of the service data #1 SSSW
SW28, prohibit the V.8 / V.34
procedure of the sending machine.
##675 RX In V.34 reception, the procedure fails to proceed
from phase 3 or 4 to the control channel or
further, causing T1 time-over
- In bit 0 of the service data #1 SSSW
SW28, prohibit the V.8 / V.34
procedure of the sending machine.
##750 TX After transmitting PPS-NULL in ECM - Try a higher transmission level.
To Next Page
Loading...
