Configure the IPsec settings on a workstation or a print server
When to do
After the IPsec configuration on the controller.
Pre-requisites
Log on the workstation with the Administration rights.
Purpose
Complete the IPsec configuration for a secure connection between the printer/copier system and
a workstation.
On the workstation, perform the 6 following actions:
1-
Add the security snap-in
on page 44
2-
Create the security policy
on page 45
3-
Create the filter list
on page 46
4-
Define the filter actions and security negotiation
on page 48
5-
Define the security rule
on page 49
6-
Assign the security policy
on page 51
NOTE
The procedure below shows the configuration steps on Windows server 2008.
The procedure is similar on other Operating Systems (Windows Server 2003, Windows XP,
Windows Vista, Windows 7)
Add the security snap-in
Procedure
1.
In the 'Start' - 'Run' window, enter 'mmc' to open the management console
2.
In the top menu select 'File' - 'Add/Remove Snap-in'
Configure the IPsec settings on a workstation or a print server
44
Chapter 2 - Security on Océ PlotWave 300/350, PlotWave 750, PlotWave 900 and ColorWave 300
To Next Page
Loading...
