Canon PC300 - Page 14

GENERAL DESCRIPTIO!
©. Making Copies
1) Switch the copier ON.
¢ If necessary, wait until the intensity of
the scanning lamp reaches the speci-
fied value.
* The wait time is about 0 second.
¢ The copier will shut itself off in about 5
minutes if left alone without key opera-
tion.
2) Lift the copyboard cover, and place a
document face down, along the size
index.
¢ Place the document so that its center
is at on the size index (Figure 1-5);
then, close the copyboard cover.
Size index
Figure 1-5
3) Adjust the copy density to suit the docu-
ment.
4) Slide the pick-up guide to suit the size of
copy paper.
5) Set copy paper on the pick-up tray.
1-8 COPYRIGHT © 1994 CANON INC.
B PC320/325/FC230
Place a stack of copy paper of a size
Suited to the document on the pick-up tray;
make sure the edges of the sheets are flush.
* The stack may be 5 mm (about 50
sheets of plain paper).
Copy paper
Figure 1-6
6) Set the copy count.
H PC320/325/FC230
Set the number of copies to make (1 to 9
or F) using the + key, and check the Copy
Count indicator.
7) Press the Copy Start key.
@ PC320/325/FC230
¢ To stop continuous copying, press the
Clear/Stop key; the copier finishes the
Ongoing copy and stops. The copy
count displays the initial count.
CANON PC300920/925, FC210/230 REVO JULY 1994 PRINTED IN JAPAN (IMPRIME AU JAPON)