Network Protocol Settings
2-3
Using the Wireless LAN Board in a Network
2
Network Protocol Settings
Before specifying the wireless LAN settings, it is necessary to specify the settings
required for the network protocol to use. Refer to the following to specify the
required settings.
Also note that the standard network settings other than [TCP/IP Settings (IPv4)],
[TCP/IP Settings (IPv6)], [DNS Settings (IPv4)], [DNS Settings (IPv6)], [NetWare
Settings], [AppleTalk Settings], and [Startup Time Settings] are also used for the
Wireless LAN Board. See e-Manual > Network to specify these settings.
IMPORTANT
For information on the security settings for the access point, see the instruction manuals
included with the access point.
NOTE
•
For details on each item, see the sections for [IPv4 Settings], [IPv6 Settings], [DNS
Settings], [WINS Settings], [NetWare Settings], [AppleTalk Settings], and [Startup
Settings] in e-Manual (Network).
•
These settings are enabled after the machine is restarted. For information on restarting
the machine, see the manual included with the machine.
■ TCP/IP Settings
Item Setting Description Default Setting
TCP/IP Settings (IPv4)
Use IPv4 On/Off On
DHCP On/Off Off
BOOTP On/Off Off
RARP On/Off Off
IP Address IPv4 Address 0.0.0.0
Subnet Mask IPv4 Address 0.0.0.0
Gateway Address IPv4 Address 0.0.0.0
WINS Resolution On/Off Off
WINS Server Address IPv4 Address 0.0.0.0
To Next Page