Einstellungen am Subwoofer
Crossover: Dieser Regler dient der
Einstellung der oberen Grenzfrequenz,
die von Ihrem Subwoofer wiedergege-
ben wird (Abb. 9). Alle Frequenzen über
dem eingestellten Wert werden mit 12
bzw. 24 dB/Oktave abgeschnitten (High
Cut) und nicht wiedergegeben. Der
Wert richtet sich in erster Linie nach der
unteren Grenzfrequenz der anderen
Lautsprecher Ihrer Anlage.
9
10
Volume: Mit dem Regler für Volume
verändern Sie die Lautstärke Ihres
Subwoofers und damit die Intensität der
Tiefbasswiedergabe (Abb. 10). Ein
Drehen nach rechts bedeutet eine
Lautstärkeerhöhung, ein Drehen nach
links eine Verringerung der Lautstärke.
Passen Sie mit Hilfe des Volume-Reglers
den Canton Subwoofer von der
Lautstärke her an die anderen Laut-
sprecher Ihrer Anlage an.
Subwoofer settings
Crossover: This control relates to the
upper cut-off frequency reproduced by
your subwoofer (fig. 9). All frequencies
above the set level will be cut off by 12
or 24 dB/octave (high cut) and not
reproduced. The level is primarily based
on the lower cut-off frequency of the
other loudspeaker in your system.
Volume: The volume control allows you
to change the volume of your
subwoofer and therefore the intensity
of the low bass reproduction (fig. 10).
Turning to the right increases the
volume and turning to the left reduces
the volume. Use the volume control to
customise the volume of the Canton
subwoofer to match the other
loudspeakers in your system.