3
11
English
10
English
Unpacking
Unpack the box carefully and check that all the following parts
are present:
Delivery content
• 1x Smart Amp 5�1
• 1x Remote control
• 1x Power cord
• 1x Short manual
Setting up the
remote control
The remote control comes with a
battery already installed� Simply
remove the protective film to
activate� When replacing the battery
ensure that it is correctly inserted
according to the polarity markings
(+/–)�
Only use the battery specified for this
system (CR 2032)�
CR 2032
OPEN CLOSE
Place the Smart Amp 5�1 in the desired location and connect
it to the power input using the power cord� Make sure that
your TV is plugged in� If you want to connect your Amp to the
WiFi network, please make sure your WiFi router is active and
has a connection to the Internet�
Connection
The remote control supplied with this device contains a button cell as battery� Swallowing the button cell
can cause serious internal burns and thus death in only 2 hours!
Do not ingest the battery, Chemical Burn Hazard�
If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention�
Take care of your environment when disposing of the battery� Batteries must be disposed of at a battery collection point�
Do not expose batteries to high temperatures, such as direct sunlight, fire or the like�
Batteries must be inserted correctly according to the polarity imprint� Incorrect insertion can lead to damage�
Only use the batteries or rechargeable batteries specified for the device�
The batteries supplied are not rechargeable batteries, i�e� these batteries must not be recharged�
The device and/or the accessory may contain small parts that can be swallowed�
Therefore not suitable for children under three years�
This symbol indicates uninsulated dangerous voltages inside the case that are sufficiently
strong (amplitude) to cause a fire or electric shock�
This symbol warns you of important operating and maintenance instructions in the
accompanying documentation (manual) supplied�
This symbol indicates Class II devices, where protection against electric shock is provided by double or
reinforced insulation during specified use and therefore no protective earth connection is required�
To Next Page
Loading...
