Attention: Should you assign a name to an input that is already assigned, the input previously assigned with this name
will be deactivated (---)� To continue using this input, you must assign it a different name�
Note: Inputs which have been deactivated “---” are no longer displayed when changing the inputs (Input button)�
This simplifies the selection of the desired input�
Note: The name for the input BT cannot be changed� If you have deactivated all inputs, BT (Bluetooth
®
) will be
permanently selected as the input�
PHA (Phase Subwoofer)
If you have paired a wireless subwoofer to the system, you can use this parameter to change its phasing relative to
the satellite speakers� The values 0° and 180° can be selected�
To change the phasing, proceed as follows:
1
Select the SYS menu as described in the chapter SYS (System Setup) and select the PHA function using the navigation buttons “ ” and “ ”.
2
Use the “+/–” buttons to set the desired value�
Note: This parameter is only available when a subwoofer is connected to the system�
SSM (Subwoofer Stereo Mode)
If you have connected a wireless subwoofer to the system, it will output all bass signals regardless of the playback mode (ST, MOV, MUS)�
For a true stereo experience, the bass signals can be reproduced in stereo mode (ST) via the front speakers (FL, FR), only�
To play back the bass signals in stereo mode (ST) through the front speakers, proceed as follows:
1
Select the SYS menu as described in the chapter SYS (System Setup) and select the SSM function using the navigation buttons “ ” and “ ”.
2
Use the “–” button to set the value to OFF� If you want the subwoofer to play the bass signals, set the value to ON using the “+” button�
Note: This parameter is only available when a subwoofer is connected to the system�
To Next Page
Loading...