WIS (Wireless Setup)
Press the M button, SPS is displayed� Now press the “
” button until WIS appears in the display� Press the OK button and
use the navigation buttons “
” and “ ” to obtain the desired setting�
WSP (Wireless Speaker Pairing)
This menu item allows you to connect other wireless speakers of the Canton Smart Series to the master� In this step, one of the speakers
will be designated as the master� If you only have devices with the suffix S or M after the type name, you can designate the preferred speaker
as the master� However, if you have speakers with the addition M and S after the type name, you should define the speaker with the addition
M as the master, as this has a USB input, a Bluetooth
®
module and a decoder for DTS
®
and Dolby
®
Digital bitstreams� By default, the master
speaker is designated as the left front speaker� Should it be in a different position, you must first assign the correct channel to it�
For this, proceed as follows:
Defining the channel assignment of the master:
1
In the master speaker, select the WIS menu as described in chapter WIS (Wireless Setup)
and use the navigation buttons “
” and “ ” to select the WSP function and press OK.
2
Use the “ ” and “ ” buttons to select the channel for the master speaker�
MFL = front left; MFR = front right, MCE = centre, MSL = surround left; MSR = surround right
3
To exit the menu, press the M button� To pair slave speakers, continue with step
4
�
Pairing the slave speakers:
4
First, perform steps
1
and
2
and press OK�
Note: If you have just performed these steps, continue with step 5�
5
Use the navigation buttons “ ” and “ ” to select the speaker you want to pair� The following channels are available:
FL=front left; FR= front right; CE= centre; SL= surround left; SR= surround right; SUB= Subwoofer�
6
Now press the OK button� The display should show PIR�
Menu Settings
To Next Page
Loading...