INSTALLATION
IMPORTANT:
ISOLATE YOUR OVEN FROM THE ELECTRICAL SUPPLY BEFORE PERFORMING
INSTALLATION OR MAINTENANCE.
Installation should be carried out according to the instructions by a professionally
qualified person only.
The manufacturer declines all responsibility for any damage to persons, animals or
materials due to incorrect installation.
FITTING THE APPLIANCE
Fit the appliance into its surround (beneath a
worktop or above another appliance in a tall
housing) by inserting screws and plastic covers
into the 2 holes (A - Fig.3) that can be seen in
the frame of the oven when the door is open.
For the most efficient air circulation, the oven
should be fitted according to the dimensions
shown in Fig.1 & 2.
The rear panel of the cabinet must be removed so that air can circulate freely.
The panel to which the oven is fitted should have a gap of at least 70mm at the
rear for ventilation (Fig.4 & Fig.5).
5
INDICATOR LIGHTS
The indicator lights situated above the control panel go on and off when the heating elements are inserted or
removed. During the thermostatic functioning of the oven, the neon light remains on until the pre-chosen
temperature is reached and when it goes out, this is a sign that the temperature has been reached. When the oven
cools, the thermostat determines the re-insertion of the heating elements with consequent re-lighting of the
indicator lights. In models the internal oven light, which is always on when any function is in operation, is
considered as an operation, is considered as an operating warning light.
performing installation or maintenance!
Installation should be carried out according to the
instructions by a professionally qualified person.
The manufacturer declines all responsibility for
any damage to persons, animals or things due to a
wrong installation.
- Fit the appliance into its surround (beneath a work-top or above another appliance) by inserting screws and
plastic covers into the 2 holes that can be seen in the frame of the oven when the door is open.
- For the most efficient air circulation, the oven should be fitted according to the dimensions shown in fig. 1-2 of
page 2.
- The rear panel of the cabinet must be removed so that air can circulate freely. The panel to which the oven is fitted
should have a gap of at least 70 mm at the rear.
NB: where ovens are to be matched with hobs, it is essential to follow the instructions contained in the
booklet supplied with the other appliance.
INSTALLING THE APPLIANCE
IMPORTANT:Unplug your oven before
Fitting the appliance