27
TROUBLESHOOTING
The oven does not operate Check it is switched on at the mains
There has been a power cut
The time is not set
The oven is not heating The thermostat is not turned to a
temperature
The interior lamp does not illuminate Check the product is connected to the
electrical supply and is switched on
Replace the bulb
Lower and upper parts of the oven are not
cooking evenly
Control the shelf location, cooking
period and temperatures according to
the manual
Display Error Reason
E 01 No sensor Temperature might be too high; oven will stop working and cooling fan
start.
E 02 Sensor short circuit Wrong sensor. Oven will stop working and cooling fan start.
E 03 Door lock Under pyrolytic mode, heating element will stop working until door is
locked well.
ERROR CODES
USEFUL NOTES FOR BAKING
In the following table are some indicative hints for baking:
Faults Causes Remedies
The upper crust is dark and
the lower part too pale
Not enough heat from the
bottom
- Use the natural convection position
- Use deeper cake tins
- Lower the temperature
- Put the cake on a lower shelf
The lower part is dark and the
upper crust too pale
Excessive heat from the
bottom
- Use the natural convection position
- Use lower side tins
- Lower the temperature
- Put the cake on a higher shelf
The outside is too cooked and
the inside not cooked enough
Too high temperature Lower the temperature and increase the
cooking time
The outside is too dry even
though it is the right colour
Too low temperature Increase the temperature and reduce
the cooking time.
To Next Page
Loading...
