Caple C2902 - Troubleshooting

23Please keep this instruction manual for future reference Instruction manual C2902
TROUBLESHOOTING
TROUBLES SOLUTION
The oven does not operate
› Check it is switched on at the mains
› There has been a power cut
› The time is not set
The oven is not heating › The thermostat is not turned to a temperature
The interior lamp does not illuminate
› Check the product is connected to the electrical supply and is
switched on
› Replace the bulb
Lower and upper parts of the oven
are not cooking evenly
› Control the shelf location, cooking period and temperatures
according to the manual
DISPLAY ERROR REASON
Er 01 No sensor.
› Sensor could not be found by PCB (or the temperature may be too
high); The oven will stop working and the cooling fan will start.
Er 02 Sensor short circuit.
› The sensor short circuits, the oven will stop working and the cooling
fan will start.
USEFUL NOTES FOR COOKING
In the following table, some indicative hints for cooking;
FAULTS CAUSES REMEDIES
The upper crust is dark and
the lower part too pale.
Not enough heat from the bottom. › Use the natural convection position
› Use deeper cake tins
› Lower the temperature
› Put the cake on a lower shelf
The lower part is dark and the
upper crust too pale.
Excessive heat from the bottom. › Use the natural convection position
› Use lower side tins
› Lower the temperature
› Put the cake on a higher shelf
The outside is too cooked and
the inside not cooked enough.
Too high temperature. › Lower the temperature and increase the
cooking time.
The outside is too dry even
though it is the right colour.
Too low temperature. › Increase the temperature and reduce
the cooking time.