Instruction manual C844i
22
Please keep this instruction manual for future reference
BEFORE INSTALLING THE HOB, MAKE SURE THAT:
- The work surface is square and level, and no structural members interfere with space
requirements.
- The work surface is made of a heat-resistant material.
- If the hob is installed above an oven, the oven has a built-in cooling fan.
- The installation will comply with all clearance requirements and applicable standards and
regulations.
- A suitable isolating switch providing full disconnection from the mains power supply is
incorporated in the permanent wiring, mounted and positioned to comply with the local wiring
rules and regulations.
- The isolating switch must be of an approved type and provide a 3mm air gap contact separation
in all poles (or in all active [phase] conductors, if the local wiring rules allow for this variation of
the requirements).
- The isolating switch will be easily accessible to the customer with the hob installed.
- You consult local building authorities and by-laws if in doubt regarding installation.
- You use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the wall surfaces
surrounding the hob.
AFTER INSTALLING THE HOB, MAKE SURE THAT:
- The power supply cable is not accessible through cupboard doors or drawers.
- There is adequate flow of fresh air from outside the cabinets to the base of the hob.
- If the hob is installed above a drawer or cupboard space, a thermal protection barrier is installed
below the base of the hob.
- The isolating switch is easily accessible by the customer.
BEFORE LOCATING THE FIXING BRACKETS
The unit should be placed on a stable, smooth surface (use the packaging). Do not apply force
onto the fixings protruding from the hob.
To Next Page
Loading...
