Instruction manual C858i
14
Please keep this instruction manual for future reference
USING YOUR INDUCTION HOB
TO START COOKING
If the display flashes
alternately with the heat setting this means that:
- You have not placed a pan on the correct cooking zone.
- The pan you’re using is not suitable for induction cooking.
- The pan is too small or not properly centred on the cooking zone.
Touch the ON/OFF control. Once turned on, the buzzer beeps once the
timer control shows ‘00’ and the heating zone selection controls
show or / Indicating that the induction hob has entered the state
of standby mode.
Place a suitable pan on the cooking zone that you wish to use.
Make sure the bottom of the pan and the surface of the cooking zone
are clean and dry.
Touch the heating zone selection control and an indicator where you
touched will flash.
Adjust the heat setting by touching the slider control. If you don’t choose
a heat setting within 1 minute, the induction hob will automatically
switch off. You will need to start again at step 1. You can modify the heat
setting at any time during cooking.
To Next Page
Loading...
