Metal Grease Filter
§ The metal grease filter should be cleaned at least every month. The filter may be washed by hand using mild soapy
water, or can be machine washed in a dishwasher.
§ Remove the metal grease filter cassette by pushing inwardly on the two steel handles; replace, making sure the
handle has sprung back into position and is completely visible.
Charcoal Filter (for re-circulation use only)
§ This is not supplied with the extractor and should be purchased from your supplier as an accessory.
§ The charcoal filter cannot be cleaned; it should be replaced approximately every three months or more often if the
hood is used for more than three hours per day.
§ To remove the charcoal filter push inwardly on the two retaining clips to disengage the security fixing and remove.
§ This appliance can be a fire hazard if the grease and charcoal filters are not cleaned and replaced as recommended.
LIGHTING
Halogen lighting
§ The lamps should be replaced with 220-240V 20W halogen spot lamp.
§ To Remove the Lamps: -
o Unscrew the two screws to release the metal surround.
o Remove a lamp from the holder by pulling the lamp downwards.
§ When fitting the new lamp ensure the two pins are correctly inserted into the slots in the lamp holder.
§ Handing the lamp with un-covered fingers will reduce the lamp life considerably..
Tungsten lighting
§ The lamps should be replaced with 220-240V 40W SES lamps.
§ To Remove the Lamps: -
o Turn off the mains power supply to the extractor.
o Remove metal grease filters
o Remove lamps by unscrewing anticlockwise.
§ Replace with new lamp screwing in clockwise.
§ Refit metal grease filters.
§ Turn on power supply.
5
To Next Page
Loading...
