Caple DD523BK - Page 12

Instruction manual DD523BK
12
Please keep this instruction manual for future reference
6. Connect the downdraft to the power supply
and check that the red button is pushed
down fully.
7. Turn on the downdraft (pressing the power
Connect the downdraft to the power
supply and check that the red button
is pushed down fully.
6.
Turn on the downdraft (pressing the
power button) and the top panel
will open. Install the
grease filters as
shown in Fig.8.
7.
8
The minimum distance between the downdraft (closed) and the surface above it must be at
least 400mm. It is the manufacturer of the hob who determines the clearance required and the
clearance quoted by the hob manufacturer must be followed.
In the absence of any instructions supplied with a gas hob, there must be a minimum space of
50mm between the edge of a gas hob and the downdraft frame.
button) and the top panel will open.
Install the grease lters as shown in Fig.8.
Connect the downdraft to the power
supply and check that the red button
is pushed down fully.
6.
Turn on the downdraft (pressing the
power button) and the top panel
will open. Install the
grease filters as
shown in Fig.8.
7.
8
The minimum distance between the downdraft (closed) and the surface above it must be at
least 400mm. It is the manufacturer of the hob who determines the clearance required and the
clearance quoted by the hob manufacturer must be followed.
In the absence of any instructions supplied with a gas hob, there must be a minimum space of
50mm between the edge of a gas hob and the downdraft frame.
Connect the downdraft to the power
supply and check that the red button
is pushed down fully.
6.
Turn on the downdraft (pressing the
power button) and the top panel
will open. Install the
grease filters as
shown in Fig.8.
7.
F
F
i
i
g
g
.
.
8
The minimum distance between the downdraft (closed) and the surface above it must be at
least 400mm. It is the manufacturer of the hob who determines the clearance required and the
clearance quoted by the hob manufacturer must be followed.
In the absence of any instructions supplied with a gas hob, there must be a minimum space of
50mm between the edge of a gas hob and the downdraft frame.
This appliance is intended to extract cooking fumes, greases and vapours. It has been designed to
work in either ventilation mode or in recirculation mode.
The minimum distance between the downdraft (closed) and the surface above it must be at
least 400mm. It is the manufacturer of the hob who determines the clearance required and the
clearance quoted by the hob manufacturer must be followed.
In the absence of any instructions supplied with a gas hob, there must be a minimum space of
50mm between the edge of a gas hob and the downdraft frame.
CAUTION:
Installation must comply with the regulations in force regarding the ventilation of enclosed
environments. The use of discontinued ducts is not allowed without the approval of a
qualied technician.