Instruction manual DD810BK
40
Please keep this instruction manual for future reference
ERROR CODE E2 IS INDICATED?
The electronic unit is too hot. Check the installation of the hob.
Make sure that there is sufficient ventilation.
See the section on “Protection against overheating”.
See the section on “Ventilation”.
ERROR CODE E8 IS INDICATED?
Fault on the left or right fan.
The suction opening is blocked or covered or the fan is defect.
Check the installation of the hob. Make sure that there is sufficient ventilation.
See the section on “Ventilation”.
ERROR CODE U400 IS INDICATED?
The hob has been incorrectly connected. The controls will switch off after 1 second and a
continuous signal will sound. Connect the appliance to the appropriate power supply.
AN ERROR CODE (ERXX OR EX) IS INDICATED?
The appliance has developed a technical defect. Please call Caple Service.
THE POT SIGN
APPEARS?
A cooking zone has been switched on and the hob is expecting a suitable pot or pan to be placed
on the cooking zone (pan recognition). Only when a pot has been placed on the cooking zone will
power be supplied.
THE POT SIGN
STILL APPEARS, EVEN THOUGH A POT OR PAN WAS
PLACED ON THE HOB?
The cookware is unsuitable for induction cooking or the pot or pan is too small.
IS THE COOKWARE YOU ARE USING MAKING NOISES?
This is due to technical reasons and perfectly normal; the induction hob and the pan are not
at risk.
DOES THE COOLING FAN STILL OPERATE AFTER IT HAS BEEN
SWITCHED OFF?
This is normal since the electronic unit is being cooled down.
To Next Page
Loading...
