Caple SO111 - Replacing the Oven Lamp; Fitting Oven Shelves

29
Please keep this instruction manual for future reference
Instruction manual SO111, SO111SS, SO111GM
REPLACING THE OVEN LAMP
- Disconnect with power supply
- Unscrew the glass cover attached to the lamp holder
- Unscrew the lamp and replace it with another high-temperature lamp (300°C) with the
following characteristics:
Replacing the oven lamp
• Disconnect with power supply
• Unscrew the glass cover attached to the lamp holder
• Unscrew the lamp and replace it with another high-temperature lamp
(300°C) with the following characteristics:
• Remount the glass cover and reconnect the appliance to the power supply
WWAARRNNIINNGG:: EEnnssuurree tthhaatt tthhee aapppplliiaannccee iiss uunnpplluuggggeedd bbeeffoorree rreeppllaacciinngg tthhee llaammpp ttoo
aavvooiidd tthhee ppoossssiibbiilliittyy ooff eelleeccttrriicc sshhoocckk..
WWaarrnniinngg:: DDoo nnoott ooppeerraattee aapppplliiaannccee iiff tthhee ssuuppppllyy ccoorrdd iiss ddaammaaggeedd oorr aafftteerr t
thhee
aapppplliiaannccee mmaallffuunnccttiioonnss,, oorr hhaass bbeeeenn ddaammaaggeedd iinn aannyy mmaannnneerr.. iiff ssoo,, ccoonnttaacctt
CCaappllee sseerrvviiccee ttoo aarrrraannggee aa sseerrvviiccee ccaallll..
Voltage: AC220V-240V
Wattage: 15W
Socket: E14
Fitting Oven Shelves
The deep pan and wired shelf have a side
edge, there edges can match with the sliding
rack on the sides of the cavity. It can prevent
the rack or tray from slipping out from the
oven.
Deep pan and wired shelf in the position 1-4
marked
- Voltage: AC220V-240V
- Wattage: 25W
- Socket: E14
- Remount the glass cover and reconnect the appliance to the power supply
WARNING:
Ensure that the appliance is unplugged before replacing the lamp to avoid the possibility of
electric shock.
WARNING:
Do not operate appliance if the supply cord is damaged or after the appliance malfunctions, or
has been damaged in any manner. if so, contact Caple service to arrange a service call.
FITTING OVEN SHELVES
The deep pan and wired shelf have a side
edge, these edges match with the moulded
sides of the cavity. This can prevent the rack
or tray from slipping out from the oven.