8555-M512-O1 Rev D 01/15 16
Basic Operation with ID
To Weigh
1. Press ON/OFF key to turn the MV1 on.
2. Press ZERO key to zero weight display. ZERO, GROSS and lb or kg annunciator will
turn on to show scale is ready for use.
3. Press ID/HEIGHT key.
4. Display will change to show Id.
5. Using numeric keys, enter up to an 14 digit alphanumeric identification number.
6. Press PRINT/ENTER key.
7. Place patient on scale
8. Read weight display.
9. If a printer is connected to scale, press PRINT/ENTER key to print a ticket.
10. Remove patient from scale.
Push Button Tare (Tare weight is NOT known)
1. In Gross Weight mode (GROSS annunciator on), place item (wheelchair, walker, etc…)
to be tared on scale.
2. Press TARE key.
3. Display will show weight of item on scale and the TARE annunciator will turn on.
4. Press PRINT/ENTER key.
5. Display will change to zero and NET annunciator will turn on to show that net weight
is being displayed. The item's weight has been entered as "tare weight".
6. Press ID/HEIGHT key.
7. Display will change to show Id.
8. Using numeric keys, enter up to an 14 digit alphanumeric identification number.
9. Press PRINT/ENTER key.
10. Place patient on scale
11. Read weight display.
12. If a printer is connected to scale, press PRINT/ENTER key to print a ticket.
13. Remove patient from scale.
IMPORTANT! Tare entry is not allowed if Auto Hold is enabled.
To Next Page
Loading...
Need help?
General