8555-M512-O1 Rev D 01/15 43
SETUP REVIEW
(Non-Protected Setup Parameters)
The MedVue Model MV1 Medical Weight Analyzer allows several operational parameters to be
reviewed and changed as necessary without having to remove the end cap and pressing the
calibration switch to enter the Calibration Setup mode.
To Enter Setup Review
With the MV1 on and in the Gross weight mode:
1. Press and hold the CLEAR ( ) key for approximately 3 seconds.
2. The display will change to show SETUP REVIEW.
3. Release the CLEAR ( ) key.
4. The display changes to show:
Refer to the instructions listed in the Calibration Setup (Non- Protected Setup Parameters)
section (page 33) of this manual for information on how to change these parameters.
Parameters in Setup Review will be processed in the following sequence:
SYSTEM
LANGUAGE
Select MV1 operation language.
bACkLIGHT
Set Backlight Intensity
KEYPAd bEEP
Enable or Disable MV1 emitting a beep when a key is pressed.
SLEEP MOdE
Disable or select number of minutes of inactivity for sleep mode
AUTO SHUT OFF
Disable or select number of minutes for automatic shutoff timer
kEY dISAbLE
Enable or Disable NET/GROSS, TARE and/or ID/HEIGHT keys
ENAbLE Id
Enable or Disable transaction storage and ID number input feature
bARCOdE
Enable or Disable barcode scanning of ID’s
USE HEIGHT
Enable or Disable Height Functions
HEIGHT UNITS
Select Centimeters or Millimeters for height measuring units
bOdY MASS IdX
Enable or Disable Body Mass Index (BMI) calculation feature
HI RESOLUTION
Enable High Resolution Weight Mode feature
SEtuP
CAL
SYSTEM
To Next Page
Loading...
Need help?
General