Cardo Systems Q1 - User Manual

ThankyouforcontactingtheCardoSystemsSupportCenter.

Wearen’tawareofanyissuesbetweenthescalariderQ1andthatversionoftheTomTomRider.Iwould
recommendtousethefollowingstepstoresetyourdevices,createanewpairing, andtestfurther.
ToresetyourscalariderQ1headset:
1.TurnthescalariderQ1moduleonbypressingandholdingtheICbuttonuntilthree(3)blueflashesappear.
2.WiththeQ1flashingslowlyinblue,pressandholdtheVolumeUpbuttonuntilyoureceivearedandblue
alternatingflash.
3.ReleasetheVolumeUpbutton.Withthedeviceflashingredandbluealternating,pressandholdtheMMbutton
forapproximatelythree(3)seconds.Theredandblueflashingshouldchangetoaslow,solidpurpleflash.
4.Theheadsetwillflashpurpleslowly,approximatelyfive(5)times,followedbythree(3)redflashes.
5.Themoduleshouldthenbepoweredoff,indicatingthattheresethasbeencompleted.Repeatthesestepswith
bothheadsets.
TocreateanewpairingbetweenyourscalariderQ1headsets:
1.TurnbothscalariderQ1modulesonbypressingandholdingtheICbuttonuntilthree(3)blueflashesappearon
eachheadset.
2.Makesurebothmodulesareinstand‐bymode,whichisindicatedbyasingle blueflasheverythree(3)seconds.
3.FromoneQ1module,pressandholdtheICbuttonuntilthemodulebeginstoflashredrapidly.Youwillseethree
redflasheslikethedeviceispoweringoff,butkeepthebuttonheldinuntilitflashesredrapidly.This is theIntercom
Pairingmode.*
4.Repeatstep3onthesecondQ1module.
5.Bothmodulesshouldcontinuetoshowarapidredflashuntiltheyhavefoundeachother.Atthattime,each
modulewillsimultaneouslyshowasolidredlightforafewseconds.Bothheadsetswillreturntostand‐bymode
simultaneouslyafterthat,indicatingthatthepairingprocesshasbeen
completed.**

*OncetheQ1moduleisinIntercomPairingmode,itwillreturntostand‐byautomaticallyaftertwo(2)minutesifa
pairingisnotcompleted.
**Ifbothmodulesdonotshowasolidredforafewsecondsandoneheadsetreturnstostand‐bymodebeforethe
other,theheadsetsdidnotcompletethepairingprocesssuccessfully.

ToresetyourTomTomRider:ToresolveaBluetoothissue,youwillalsoneedtoresetyourGPStofactorysettings.
OnmostTomTomRiders,thiscanbedonebythroughthesettingsmenu.(Note:Thisresetwillrestorethedevicesto
itsfactorysettings.Alluserdatawillbe
erased.PleaserefertotheTomTommanualforinstructionsonba ckingup
anydatayouwishtosave).


Cardo Systems Q1 Specifications