5 . D R I V IN G ON T H E R OAD
■ Starting and Driving
1. Make sure the seat is installed properly.
2. Make sure the tiller has been secured properly.
3. Turn the power switch to ‘ON’.
4. Check the battery indicator to ensure there is enough power for your journey. If you have
any doubt about the remaining power, please recharge batteries before departure.
5. Set the speed dial to a position you feel safe and comfortable with.
6. Check the forward / reverse speed lever works correctly.
7. Make sure the electromagnetic brake works correctly.
8. Before driving, check your way is clear.
Attention
1. Do not push both RH & LH sides of the speed control lever simultaneously - control of your
scooter will be affected.
2. Do not turn the power switch to ‘OFF’ while driving as this will lead to an emergency stop
and possible risk of accident and injury.
3. Do not set to the highest speed whilst driving indoors.
4. Do not adjust the speed dial whilst driving as a sudden change in speed may cause danger
to you and others, and may cause damage to your scooter.
5. Do not place magnetic devices near the area of the operation handle as this could affect
the safe operation of your scooter.
6. Do be careful whilst driving in heavy traffic or crowded areas.
7. Whilst reversing the vehicle, be aware of people or objects behind you.
Stopping
1. Release the speed control lever completely. The vehicle will naturally brake and stop.
2. Turn the power off. Then remove the key.
Attention
1.The stopping distance will vary with your forward / reverse speed. Therefore please begin
braking as early as you can.
2.When parking your scooter, be sure to park on flat ground and then turn the power to ‘OFF’
before you dismount.
To Next Page
Loading...
