Carel MPXone - Page 23

23
ENG
mpxone +0300086EN rel. 2.2 - 13.11.2023
Installation
Procedure for setting the default parameters/loading the parameter set
Set 0, called the working set, contains the set of parameters used by MPXone during normal operation. This set is loaded when-
ever MPXone is started, and the parameters can be modified at any time from the terminal, supervisor, APPLICA app and con-
figuration software. The other two sets of parameters, numbered 1 and 2, contain other lists of parameters, preloaded by CAREL
during production, which can be copied as desired to the working set (Set 0). These sets of parameters, unlike Set 0, can only be
modified using the appropriate configuration software (SPARK). The sets of parameters, once differentiated by the manufacturer
of the unit, can be loaded so as to rapidly set a list of parameters, with corresponding values, to control the refrigeration system.
User terminal
Procedure:
1. power down the controller;
2. press PRG:
3. power up the controller again while holding PRG: at the end, the number 0 is displayed, which signifies the parameters have
been reset to the default values;
4. to reset the parameters to the default values (CAREL), press PRG and select 0, otherwise go to step 5;
5. power the controller off and on again
6. press UP/DOWN to choose the set of parameters (1 or 2) to be loaded as the working set, and confirm by pressing PRG;
7. complete (if required) the commissioning procedure (see “Commissioning”)
Applica
Procedure:
1. open Applica on the smartphone;
2. access the controller via NFC or Bluetooth, entering your profile credentials;
3. follow the path “Configurations/Configuration list”;
4. select the “Default” or “Custom” label;
5. if required, confirm the configuration to be opened (if connected to the controller via NFC, select Upload at the top right and
move the smartphone closer to MPXone, while via Bluetooth the update will be completed automatically).
2.15 Applica: copy conguration
To simplify operations in the field, Applica includes a “Clone” feature to acquire the configuration from one unit and replicate it
“one-for-one” to other cabinets.
Procedure:
1. open Applica on the smartphone;
2. access the controller via NFC or Bluetooth, entering the profile credentials;
3. follow the path “Configurations/Clone”;
4. move the smartphone closer to the MPXone to acquire the configuration from;
5. following the acknowledgement message, move the smartphone closer to the MPXone to apply the same configuration to;
6. wait for the cloning confirmation message to be shown.
2.16 Applica: date/time and time bands
It is possible to set smartphone’s date and time on the controller, via the drop-down menu on the side, selecting “settings-->de-
vice-->set date/time”.
To set the day/night time bands:
Procedure:
1. open Applica on the smartphone;
2. access the controller via NFC or Bluetooth, entering your profile credentials;
3. open the “Scheduler” section;
4. define the day/night time bands for the different days of the week;
5. apply the set schedule to the controller (upload button at the top-right for connection via NFC).
Notice: 8 daily time bands can be configured by setting parameters tS1, tE1 to tS8, tE8.