What to do if Carestream DENTAL equipment displays 'LOC' after triggering the exposure switch?
If the exposing button shuts down abnormally, and the “LOC” message is displayed on the LCD screen, release it using the light button.
How to fix E02 error (tube current under) on Carestream DENTAL equipment?
If the tube current is lower than the set tube current, the CS 2400P will require authorized service.
What causes the E03 error (Generator High voltage cable disconnect) in Carestream DENTAL equipment?
The E03 error indicates that the generator high voltage cable is not connected. In this case, the CS 2400P will require authorized service.
General| Sensor Type | CMOS |
|---|---|
| Image Receptor | Digital sensor |
| Connectivity | USB |
| Tube Current | 7 mA |
| SID (Source to Image Receptor Distance) | 20 cm |
| Type | Intraoral X-Ray |
| Generator Type | High frequency |
| Tube Voltage | 60 kV |
| Total Filtration | 2.5 mm Al equivalent |
| Power Requirements | 50/60 Hz |
To Next Page
