2011-01-05 9G5124_en 1
Getting Started
Requirements to install the laser imager
IMPORTANT: The laser imager weighs approximately 53.52 kg (118 lb).
Two people must use safe lifting techniques to move the
laser imager. One person can complete the remaining
steps.
Required tools • Scissors
• Straight blade screwdriver
• Phillips screwdriver
Required information You will need:
• IP Address and related network information for the laser imager
• Configuration information for each modality that will print to the laser
imager
This information should have been previously collected and recorded in
the Site Readiness manual that was provided to your site. In the Site
Readiness manual, see the sections, “Network Requirements” and
“Modality Configuration.”
If you do not have this Site Readiness manual, contact your dealer.
Task Recommended Skill or Knowledge
Unpack the laser imager. Ability to use common hand tools.
Use a personal computer to view the documentation on
the publications disc supplied with the laser imager.
Basic personal computer skills.
Connect a personal computer to the laser imager and
enter the network information.
Familiarity with TCP/IP network addressing
conventions.
Configure the laser imager to print from a modality. Familiarity with DICOM protocol.
Make a backup disk of the configuration. Understand personal computer file name
conventions.
To Next Page
