What to do if Carestream CS 9300C Medical Equipment interface is inactive?
If the interface of your Carestream Medical Equipment is inactive, verify that the unit is switched ON. Allow time for the connection to establish between the unit and the PC. Also, ensure that the Acquisition interface is not hidden by another application; if it is, close the application that is masking it.
What to do for X-ray tube cooling in Carestream CS 9300C?
For X-ray tube cooling with Carestream Medical Equipment, wait until the Generator Cooling Indicator on the Acquisition interface reaches zero.
What to do in case of thermal security issues with Carestream CS 9300C?
In case of thermal security issues with Carestream Medical Equipment, wait until the Generator Cooling Indicator on the Acquisition interface reaches zero.
What to do if the Carestream CS 9300C sensor is in movement?
If the sensor in your Carestream Medical Equipment is in movement, wait for the end of the positioning process.
What to do if I need to release the handswitch on Carestream Medical Equipment?
To release the handswitch on Carestream Medical Equipment, release the exposure button of the X-ray remote control.
How to cool the Ceph sensor on Carestream Medical Equipment?
To cool the Ceph sensor on your Carestream Medical Equipment, wait until the Ready Indicator LED turns green.
How to adjust head clamps position on Carestream CS 9300C Medical Equipment?
To adjust the head clamps position on Carestream Medical Equipment, manually position the head clamps for the selected exam.
Allows selection of radiological exams and acquisition formats.
Enables selection of patient parameters influencing image quality.
Allows manual adjustment of exposure parameters for image acquisition.
Step-by-step guide to powering on the CS 9300C unit and establishing connection.
Instructions for launching the Kodak Dental or CS Imaging software.
Instructions for performing a lateral cephalometric image acquisition.
Guide for acquiring frontal AP or PA cephalometric images.
Instructions on how to perform an oblique cephalometric image acquisition.
Guide for acquiring submento-vertex cephalometric images.
Instructions for acquiring a carpus image for growth assessment.
Common issues and their solutions for the CS 9300C system.
General| Software | CS Imaging Software |
|---|---|
| Generator Voltage | 60-90 kVp |
| Generator Current | 2-15 mA |
| Type | Cone Beam Computed Tomography (CBCT) |
| Imaging Modes | Panoramic, Cephalometric |
| Field of View (FOV) | 5x5 cm to 17x13.5 cm (adjustable) |
| Radiation Dose | Low-dose protocols available |
| Connectivity | DICOM compliant |
| Scan Time | 5 to 20 seconds (depending on mode) |
| X-ray Generator | High-frequency generator |
| Patient Positioning | Standing, sitting, or wheelchair access |
| Power Requirements | 220-240 V, 50/60 Hz |
To Next Page