EN
www.carlisleft.com 77-3345 R1.1 (06/2022)
25 / 62
Be sure to store all removed parts in a safe place.
5. Disassembly instructions:
Fasten the applicator to a vice with soft jaws (1) then unscrew the three screws (2) and remove the
cylinder cover (3) and the springs (4).
Remove the seal (5) then push the needles or pull the pistons to a position where you can access the
screws (6) that holds the pistons to the needles. Loosen the two screws (7) that hold each piston to its
needle and remove the piston (8) from the needle. Remove the seal (9) and the guide rings (10) from the
piston (8).
2
Always use a vice with ”soft jaws”.
NOTE
3
4
1 1
5 6
7
8
10
9
To Next Page
Loading...
