7
How to Attach the Handle to the
Vacuum Cleaner
Models: CPU-3N, CPU-4N and CPU-4T
The vacuum cleaner and the handle are
packed separately.
1. Remove the handle screw, insert handle
into the hole on top of the vacuum
cleaner (Fig. 1).
2. Line up the small hole on the handle
with the small hole on the vacuum
cleaner, and insert the screw. Make
sure the screw is tightened securely.
How to Attach the Cord Retainer
to the Handle
Models: CPU-4N and CPU-4T
1. Pull apart the rounded end of the cord
retainer to open it up enough to fit
around the vacuum handle (Fig. 2).
2. Attach the cord retainer around the
vacuum handle (Fig. 3).
3. Create a loop in the power cord and
push it through the slot and over the
hook of the cord retainer (Fig. 4).
4. Pull down on the power cord to remove
any slack (Fig. 4).
On/Off Switch
1. To turn the vacuum on, push the switch
located on the dust compartment to the
( I ) position (Fig. 5).
2. To turn the vacuum off, push the switch
located on the dust compartment on
the ( 0 ) position.
HOW TO ASSEMBLE AND OPERATE THE VACUUM
Fig. 1
Fig. 2 Fig. 3
Fig. 4 Fig. 5
To Next Page
Loading...
Need help?
General
