5
Edge Cleaning
The edge cleaning feature provides improved cleaning near walls and stationary furniture� For
maximum edge cleaning, place the left side of the nozzle from the user’s perspective against the wall
or stationary furniture�
Automatic Carpet Height Adjustment
Your vacuum cleaner is designed with an automatic, self-adjusting nozzle� No manual adjustments are
required� The height of the nozzle is instantly and automatically adjusted to the flooring surface� This
self-adjusting feature allows the nozzle to float evenly over all flooring surfaces�
Commercial Model
Bare Floor Cleaning
Your vacuum cleaner comes equipped with a squeegee on the bottom of the vacuum to improve its
effectiveness in cleaning bare floors (figure 6)� When cleaning tile, hardwood, linoleum, etc�, use the
On setting, as opposed to the maximum power setting for best results�
Fig. 1
Fig. 2
Fig. 3
Fig. 4 Fig. 5
How to Assemble the Vacuum
Vacuum Features
Installing the Handle
The vacuum cleaner handle is packed as a separate component that requires assembly�
1� Release the handle bracket from the handle tube by removing the two screws
(figure 1)�
2� Place handle onto the handle tube, aligning holes with pegs (figure 2)�
3� Place the handle bracket back into position (figure 3)�
4� Secure with two screws removed in step 1�
5� Thread cord through cord guides and proceed with wrapping the cord (figures 4 & 5)�
6� Wrap the cord around the top and bottom cord hooks� Fasten the plug to the
wrapped cord using the channel on the plug� When not in use, store the vacuum
indoors in a clean, dry area where it cannot be damaged or cause injury�
Commercial Model
On/Off 2 Speed Switch
The switch, located on the vacuum handle, is a three-way switch� The middle position
is the Off setting, the rear position is the On setting and the forward position is for
maximum power�
Use the maximum power setting for carpet cleaning and the On setting for cleaning bare
floors and throw rugs�
Pull the switch backward to turn the vacuum on� Push the switch halfway back to turn
the vacuum off� Push the switch all the way forward to use the maximum power setting�
The vacuum cleaner should be turned off before returning the handle to its full upright
position� Always turn the vacuum cleaner off before unplugging it from the electrical
outlet�
Household Model
On/Off Single Speed Switch
The switch, located on the handle is a single speed switch� Push the switch forward to
turn the machine on� Push the switch back to turn the machine off�
Fig. 6
To Next Page
Loading...
Need help?
General
