Carrier 09PE - Lifting CLUSTER Units; Instructions for Placing the Feet in the Operating Position

5.3 - Lifting CLUSTER units
NEVER LIFT BOTH UNITS TOGETHER
 Separate the two units by removing the bolts connecting the feet
 Remove the upper unit
 Remove the second unit
(The plastic shims and bolts will be recycled)
5.4 - Instructions for placing the feet in the operating position
■ The feet are in the "transport" position (A) when the unit is delivered.
■ When the unit is nally installed, the feet must be moved to the "use" position (B).
To do this:
  Lift the upper unit using the lifting rings. Keep the unit raised throughout the procedure.
  Unscrew the 4 mounting bolts on each foot. The other bolts must never be unscrewed. Pull out the foot to reposition it
one notch lower, in its nal position.
 Retighten the 4 bolts on each foot, then reposition the unit on the ground.


AB
2
1
3
For the "Skid container" and/or raised feet option, see the additional instructions enclosed with the unit.
2
1
5 - INSTRUCTIONS FOR LIFTING AND PLACING THE FEET IN THE OPERATING
POSITION AND FOR SHIPPING
7