Carrier 19XL series - Rig Machine Assembly

Rig Machine Assembly
See rigging instructions on label attached to machine. Also refer to rigging guide Figure 3,
physical data in Figure 4, and Table 1, Table 2, Table 3, Table 4, Table 5A and Table 5B.
Lift
machine only from the 3 points indicated in rigging guide.
Each lifting cable or chain must be
capable of supporting the entire weight of the machine.
Lifting machine from points other than those specified may result in serious dam-
age to the unit and personal injury. Rigging equipment and procedures must be
adequate for machine weight. See
Table 1
,
Table 2
,
Table 3
,
Table 4
,
Table 5A
, and
Table 5B
for machine weights.
Note: These weights are broken down into component sections for use when
installing the unit in sections. For the complete machine weight, add all compo-
nent sections and refrigerant charge together. See
Table 1
,
Table 2
,
Table 3
,
Table 4
,
Table 5A
, and
Table 5B
for machine component weights.
WARNING
!
WARNING
IMPORTANT: Make sure that rigging cable is over the rigging bar before lifting.