Programming Occupied & Unoccupied Periods
16
Adjust the stop time
for Occupied 1.
Select Occupied 1 to run on
this day (On), or not to run
this day (O).
If no is selected, as in previous steps ashing prompts for input will appear for start
and stop times for Occupied 1. If more than one occupied period was selected on
page 13, then cool/heat setpoints, and start/stop times for additional occupied
periods will be prompted.
Select Yes or No to copy the pre-
vious day’s program to this day.
Yes
No
On
O
Selecting Yes, then pressing mode will copy the
previous day’s program and then will ask the
same copy question again. If yes is selected each
time, this routine will repeat until Saturday is
copied to Sunday. After Saturday is copied to
Sunday, the copy command is unavailable.
MODE
Press
MODE
Press
If Yes is selected:
If No is
selected:
Press
MODE
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
