Carrier 33CSSP3-FC - Programming Notes and Logic

Programming Occupied & Unoccupied Periods
17
PROGRAMMING NOTES
You will be prompted to enter both heat and cool setpoints even if the
thermostat is congured for heat only, or cool only.
• Ifonly1Occupiedperiodisselected,theOccupied2&3stepswillbeskipped.
Further, if only 2 occupieds are selected, the Occupied 3 steps will be skipped.
• Heat&CoolsetpointsforOccupied1arethesameforeachday.Heat&
CoolsetpointsforOccupied2&3canbeadjusteddierentlyforeachday,if
desired.
• If the start time is set for later than the stop time, the program will
run from the start time to midnight and from midnight to the stop time
on the same day. For example: 9:00pm start, 8:00am stop, on MTWTF. This
program will run from 12:00am MTWTF to 8:00am MTWTF and again from
9:00pm MTWTF to 12:00pm MTWTF.
• TheUnoccupiedsettingstakeeectatalltimeswhen:(1)theprogramis
on and (2) the current time is outside a preset occupied period. For this
reason start and stop times aren’t necessary for unoccupied.
• Ifthesame start and stop times are programmed in for an occupied
period, then it will run 24 hours.
• Ifoneoccupiedperiodstartsandstopswithinanotheroccupiedperiod,the
lower occupied # has priority. For example: If Occupied 3 is programmed
to be “on” 24 hours, and Occupied 2 is programmed to run that day, then
Occupied 2 settings will take over from Occupied 3 between Occupied 2
start and stop times.
• WhenthetimeperiodprogrammingforUnoccupiedisintheOverride
mode(seepage12),theHeat&CoolsetpointsforOccupied1areused.
Downloaded from ManualsNet.com search engine