45MAHAQ: Installation Instructions
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
23
WIRELESS REMOTE CONTROLLER
INSTALLATION
Fig. 37 — Wireless Remote Controller (RG10L5)
To attach the mounting bracket:
1. Use the two screws supplied with the wireless remote control to attach
the mounting bracket to the wall in a location selected by the customer
and within operating range.
2. Install the batteries in the remote control.
3. Place the remote control into the remote control mounting bracket.
NOTE: For remote control operation, refer to the remote control’s
owners manual.
OPTIONAL WIRED WALL-MOUNTED
REMOTE CONTROL INSTALLATION
The wired remote controller comes with the following items:
• A set of installation instructions and owner's manuals
• 3 M4X20 Screws to mount on the wall
• 4 wall plugs to mount on the wall
• 2 M4X25 to mount on switch box
• 2 plastic screw bars to fix on switch box
• 1 set of batteries
• 1 set of connecting wires to connect to indoor unit’s main board
Fig. 38 — Wired Controller
To connect the wired remote controller to the indoor units, connect to the
4-pin connector located on the display board.
To connect the wired remote controller to the indoor units:
1. Replace the display board with the shipped with the kit.
2. Install the adapter board (shipped with the kit).
3. Connect the adapter board to the new display board. Follow the
instructions on the wired controller installation instructions manual for
more details.
4. Connect the female molex plug on the adapter board to the male molex
plug from the extension cable shipped with the kit.
5. Connect the extension cable to the wired controller
For setup instructions, refer to the controller installation manual.
To Next Page
Loading...
