45MAHAQ: Installation Instructions
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
7
ACCESSORIES
The system is shipped with the following accessories. Use all of the installation parts and accessories to install the system. Improper installation may
result in water leakage, electrical shock and fire, or cause the equipment to fail. Keep the installation manual in a safe place and do not discard any
other accessories until the installation has been completed.
Table 3 — Accessories
NAME SHAPE QUANTITY
Manual 2
Drain Joint 1
Seal 1
Mounting plate+ Cardboard 1+1
Anchor 5
Mounting Plate Screw 5
Remote Controller 1
Batteries 2
Remote Controller holder 1
Remote Controller Holder Screw 2
Small Filter
(Must be installed on the back of main air filter by an authorized
technician while installing the Mounting plate to the machine)
1-2
Transfer connector
(
3/4in(19mm) transfer to 5/8in(16mm).
Shipped with the indoor unit for the North American market 33K
hyper heat unit only.)
NOTE: In North America market, when 33K hyper heat
indoor unit matches with multi-zone condensers,
you must purchase pipe with liquid side 3/8in
(9.52mm) and gas side 5/8in (16mm).The transfer
connector must be installed on the indoor unit gas
side to meet the pipe size.
1
Copper Nut
NOTE: Used to connect the connecting pipe between the
indoor and outdoor units
2
FROM EDGE TO HOLE CENTER:50mm
FROM EDGE TO HOLE CENTER:100mm
150
100
100
100
50
50
50
2
2
2
4
4
4
6
RECOMMAND
LIQUID
GAS
BUBBLE
LEVEL
mm
inch
mm
inch
To Next Page
Loading...
