Carrier 38MBRC Series - Page 48

38MBRC: Service Manual
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
48
Procedure Illustration
1) Remove 2 screws to disconnect the
power supply wires.
2) Remove 3 screws to disconnect the
wires connected to the compressor.
3) Remove 3 screws to remove the
radiator.
4) Disconnect the wires between the IPM
module board and main control
board.
5) Remove the 4 screws and loosen
the 4 hooks then remove the IPM
IPM module board.
6) Remove the 1 screw and disconnect
the wires then remove the 24V board.
DC Fan motors
Compressor
connect to main control board