Carrier 40TGV0481UP - Page 93

No. Part name Procedure Remarks
4
Ceiling panel
1. Detachment
1) Carry out works of item 1 of 2 and item
1 of 3.
2) Remove the flap connector
(CN510, White, 20P) and signal
receiving unit connector (CN214)
connected to the control P.C. board and
then remove the lead wire from the
clamps.
NOTE :
Unlock the lock of the housing part and
then remove the connector.
3) Loosen the panel fixing 4 screws
4) Slide the panel fixing bracket
(4 positions) outward.
5) Push the tentative bracket outward and
then remove the ceiling panel.
2. Attachment
1) Insert the tentative brackets (2 positions)
of the ceiling panel into square holes of
the indoor unit and then hook the panel
tentatively.
NOTE :
The ceiling panel has the directional
properties against the indoor unit.
Direct the louver motor wire to the electric
parts box side of the indoor unit.
2) Pass the head of the panel fixing
screw through hole of the panel fixing
bracket and then slide the panel fixing
bracket inward.
3) Tighten in the panel fixing screw to fix
the ceiling panel.
4) Following to work of item 2 of 3, attach
the adjust corner cap as before.
5) Connect the louver connector
(CN510, White, 20P) as before and then
fix the lead wire with clamp
6) Following to work of item 2 of 2, mount
the electric parts box cover and the
suction grille as before.
Square hole of indoor unit
Panel fixing screw
Electric parts box
LouvLouv
er motor wirer motor wiringing
Tentative bracket Ceiling panel
Square hole of indoor unit
Square hole of indoor unit
Sliding direction Sliding direction
P
anel fixing screanel fixing screw
P
anel fixing branel fixing brac
k
et
Inner sideInner side
Outer sideOuter side
Sliding direction
Panel fixing screw
Panel fixing bracket
Inner side
Outer side
Push in case Push in case
of remoof remo
vingving
Push in case
of removing
Tentative bracket
Louver motor wiring
Clamp
CN510
Louver motor wiring
Electrical
control
box
Signal
receiving
Clamps Clamping claw
CN214
- 93 -