No. Part name Procedure Remarks
5
Control P.C.
board
1. Detachment
1) Carry out work of item 1 of 2.
2) Remove connectors which are
connected from the control P.C. board
to the other parts and then remove
wiring from the clamp.
CN510 : Louver motor (20P, White)
CN60 : Signal receiving unit
(6P, White)
CN214 : Signal receiving unit
(3P, White)
CN34 : Float switch (3P, Red)
CN504 : Drain pump (2P, White)
CN101 : TC sensor (2P, Black)
CN102 : TCJ sensor (2P, Red)
CN104 : Room temp. Sensor
(2P, Yellow)
CN333 : Fan motor power supply
(5P, White)
CN334 : Fan motor position detection
(3P, White)
NOTE :
Unlock the lock of the housing part and
then remove the connector.
3) Unlock the locks of the card edge
spacer (4 positions) and then remove
the control P.C. board.
2. Attachment
1) Fix the control P.C. board to the card
edge spacer (6 positions)
2) Connect the connector removed in item
1 as before and then fix the wiring wit
the clamp.
3) Following to work of item 2 of 2, mount
the electric parts box cover and the
suction grille as before.
Clamp
Card edge spacerCard edge spacerCard edge spacer
To Next Page
Loading...
