No. Part name Procedure Remarks
6
Drain cap
1. Detachment
1) Carry out work of item 1 of 1.
2) Loosen screws (3 positions) fixing th
drain cap (outside) and then turn the
drain cap to the arrow mark direction to
remove it.
NOTE :
The drain cap is hung down because a
strap is attached to it (outside).
3) Loosen the cap by turn the drain cap
(inside) for approx. 1 turn to OPEN
→
direction and then drain the drain water
accumulated in the drain pan.
NOTE :
Be sure to catch drain water using a
bucket, etc. when loosening the drain cap.
The insulating materials are adhered to
the drain cap (outside) and opening part of
the drain pan; be careful that they are not
come off.
If they are come off, stick them as before
using double-faces tape, etc.
4) Turn the drain cap once again to OPEN
→
direction to remove it.
2. Attachment
1) Insert the drain cap (inside), turn it to
CLOSE
→
direction until the position
where “Clashed sound” is heard and it
cannot be turned more over
(Position where
>
mark of the drain pan
matches with
>
mark of the drain cap
(inside)) and then fix it
NOTE :
When attaching the drain cap (inside),
remove dirt attached to the packing.
And tighten in it noting so that the cap is
not slantingly set.
If attaching the drain cap as dust or dirt is
attached or the cap is set slantingly, water
leakage is caused.
2) Turn the drain cap (outside) to
→
direction and then attach it using the
fixing screw as original
3) Following to work of item 2 of 1, mount
the suction grille as before.
DrDrain pan marain pan markDrain pan mark
DrDrain cap marain cap markDrain cap mark
Drain cap (outside)
Strap
Drain cap (inside)
Drain cap fixing screws
CLOSECLOSE
OPENOPEN
CLOSECLOSE
OPENOPEN
CLOSE
OPEN
CLOSE
OPEN
To Next Page
Loading...
