2. INDOOR UNIT INSTALLATION
GB-12
1.
Remove the air filter from the flange (two
locations).
Remove the flange from the rear side.
Remove the ventilation panel from the
bottom side.
2.
Attach the seal sponge at the place showing in
the following diagram.
Reinstall the removed flange at the bottom and
reinstall the removed the ventilation panel at the
rear side.
3.
Attach the air filter to the flange in the manner shown in the diagram.
Flange
or
Seal sponge
2.6 CHANGE THE AIR VENTILATION DIRECTION (Alternative: Rear or Bottom)
NOTE
For standard unit, air intakes from rear side. Air intake direction can be modify at site from rear side
to bottom side following the process in below.
2.7 INSTALL FRESH AIR DUCT
All the indoor units reserve the hole to joint the fresh air pipe. The hole size as following:
Duct joint for fresh air
80mm
80mm
Ø90mm
Ø125mm
Ø160mm
MODLE
42QSS009/012 42QSS018~060
GB
To Next Page
Loading...
