Carrier 42UQV050M Series - Installation Diagram of Indoor and Outdoor Units; Optional Installation Parts

Carrier 1110651814 (EN)
3
ES
FR
IT
VT
PL
RU
CR
TR
NL
GR
SV
FI
DK
BG
EE
SK
SI
EN
Shield pipe
Air filter
Hook
170 mm or more
50 mm or more
170 mm or more
1 Installation
plate
INSTALLATION DIAGRAM OF INDOOR AND OUTDOOR UNITS
Part
code
Parts name Q’ty
A
Refrigerant piping
Liquid side : ∅6.35 mm
Gas side : ∅12.70 mm
One
each
B
Pipe insulating material
(polyethylene foam, 8 mm thick)
1
C
Putty, PVC tapes
One
each
Optional Installation Parts
•
Secure the outdoor unit with fixing bolts and nuts if the unit is likely to be exposed
to a strong wind.
•
Use ∅8 mm or ∅10 mm anchor bolts and nuts.
•
If it is necessary to drain the defrost water, attach drain nipple 9 and cap water
proof ! to the bottom plate of the outdoor unit before installing it.
Fixing bolt arrangement of outdoor unit
Insulate the refrigerant pipes
separately with insulation, not
together.
8 mm thick heat resisting
polyethylene foam
3 Batteries
2 Wireless remote control
108 mm
600 mm
28 mm
25 mm
90 mm
125 mm
320 mm
86 mm 102 mm
Air outlet
Drain outlet
Air inlet
Wall
For the rear left and left piping
Insert the cushion between the
indoor unit and wall, and tilt the
indoor unit for better operation.
Do not allow the drain hose to get
slack.
Make sure to run the drain hose
sloped downward.
Cut the piping
hole sloped
slightly.
(Attach to the front panel.)
The provided Remote Controller is a
wireless type, which also can be used
as a wire.
Please see “How to Connect
The Remote Controller for Wired
Operation”, in case of wired control is
required.
When installing the outdoor unit, leave
open in at least two of direction (A),
(B), (C) and (D) shown in the figure on
the right.
Remark :
•
Detail of accessory and installation
parts can see in the accessory sheet.
•
Some pictures might be different from
the actual parts.
6 Filter
5 Filter
Hook
8 Flat head
wood screw
& Flat head wood screw
( Battery cover
8 Flat head
wood screw
4 Remote control holder
The auxiliary piping can be
connected to the left, rear left, rear
right, right, bottom right or bottom
left.
Right
Rear right
Left
Bottom right
Rear
left
Bottom left
Vinyl tape
Apply after carrying
out a drainage test.
Saddle
Extension drain hose
(Not available,
provided by installer)
100 mm or more
100 mm or more
600 mm or more
600 mm or more
(B)
(A)
(D)
(C)
600 mm or more