Setting the hour
(Button N)
1. With the remote control
connected or disconnected,
press button .
2. The numbers of the hour
start flashing. Press button
∧ or ∨ to set the desired
hour.
Press button to switch to
the minutes, in order to set
them.
3. To make this selection,
always use buttons
∧ or ∨.
4. After setting the hour, press
button to confirm.
NOTE
“Address” Selector
• If there are two indoor units in the
same room, you can connect one
remote control to one indoor unit
and the other remote control to the
other unit, or you can control both
units using just one remote control.
• For the configuration, consult the
Installation & Start-up Instruction’s
Manual.
CAUTION !!!
The air conditioner will not work if there are
curtains, doors or other objects blocking the
signal sent from the remote control to the
unit.
If the infrared signal receiver of the indoor
unit is directly exposed to the sun’s rays,
the equipment will not function properly.
Block the incidence of sunlight until the
exposure has been eliminated.
Together with the remote control, you will
receive a mounting support to put it inside.
Attached the support the wall.
NOTE
Always use the remote control to set
the position of the air deflectors;
otherwise operational anomalies
may result. Disconnect the unit and
reconnect it when manually setting
the grid outside of the range.
16
To Next Page
Loading...
