If you want the daily operating mode to start at
530pm and stop at 10:30pm, proceed as
follows:
1. Select timer ON for 5:30pm
2. Select timer OFF for 10:30pm
3. Press the button of the daily operating mode
(Button )
Canceling the ON, OFF and DAILY
TIMER programming
1. If you want to cancel the selection of ON or
OFF timer, press the buttons, following this
sequence:
• Button or
• Button X
To deactivate the daily operating mode
function, press button
NOTE
The daily operation function will remain
active until one of the two timers (ON or
OFF) is activated.
Programming the night timer
(SLEEP - button M)
Press this button to set the night timer (SLEEP)
with the remote control connected. The icon
appears on the display. This procedure allows
you to set the remaining operating time of the
unit.
1. “1:hr” appears on the display, together with
the icon.
2.
Press button ∧. The
display shows the
following selections in
the sequence:
1 hr, 2 hr, 3 hr, 4 hr, 5 hr,
6 hr, 7 hr, 8 hr and 9 hr
3. Once you have selected - using the buttons
∧ or ∨ - the remaining operating hours,
press button again to confirm.
4. After the night timer has been set, the unit
will check the selected temperature to
prevent excessive cooling during operation.
Buttons for setting the time and
resetting
(Button N and O)
Press the clock setting button to adjust the
real time. Press the button “o” with a sharp-
pointed object, if the remote control is not
working properly or after replacing the
batteries.
15
To Next Page
Loading...
