Carrier 50CD - Page 11

Fig. 18 — Baffle Installation Details
Fig. 19 — Vent Position Setting Details
11. If vent air is not required, go on to step 12. If
vent air is required, proceed as follows:
a. Turn on base unit power. This energizes the
evaporator fan motor.
b. Slide economizer out of unit so that access
hole to vent position setscrew is visible See
Fig. 19.
c. Adjust vent opening by loosening vent posi¬
tion setscrew on left side of economizer
damper motor and setting vent position
lever to adjust damper. See Fig. 19. Move
vent position lever back toward evaporator
coil to close damper or forward to open
damper. When adjustment is completed,
retighten setscrew.
d. 1 urn off base unit power and remove jumper
from red and black wires.
e. Slide economizer assembly back into unit.
12. Remove tape from outdoor air thermostat
(OAT.) and cooling lockout switch (CLS), and
fasten to inside of hood with screws and speed
clips provided. Make sure terminals on OAT
are up. See Fig. 20.
Fig. 20 — Outdoor Air Thermostat/
Enthalpy Control and Cooling Lockout
Switch Installation
11