Need help?Do you have a question about the Carrier 61AF and is the answer not in the manual?
General safety precautions for installation, start-up, and servicing of the equipment.
Precautions regarding electrical components and qualified personnel for safe access.
General description of terminal block contacts, some used only in remote mode.
Table detailing connectors, types, terminals, and descriptions for the NRCP2-BASE board.
Lists different interface screens: default, menu, data, operating mode, password, parameter modification.
Guides on modifying configuration parameters using cursor and Enter key.
Visual representation of the Pro-Dialog+ menu hierarchy and navigation paths.
Details parameters in the GENUNIT menu, including control type, status, and setpoint selection.
Covers alarm reset, current alarms, and alarm history.
Details alarm reset functionality and lists current alarms.
Summarizes unit control types and stop/go status based on operating type and schedule.
Describes interlock contact function and how heaters/pumps protect against frost.
Explains Pro-Dialog capacity limitation and how compressor stages maintain water temperature.
Details linking two Pro-Dialog+ units for master/slave operation via CCN bus.
Overview of Pro-Dialog+'s fault tracing aids and access to operating conditions via menus.
Details alarms related to thermistor and pressure transducer faults and their causes.
Covers communication loss alarms and process issues like frost protection and suction temperature.
Continues listing process fault alarms like water flow, customer interlock, and maintenance alerts.
To Next Page
General