15
S Secure mounting plastic to wall using two screws and anchors p rovided.
S Adjust length and routing of each wire to reach each wire entry on the
connector backplate. Strip 1/4-- in (6.4 mm) of insulation fro m each wire.
S Match and connect thermostat wires to proper terminals on control backplate.
d See wiring diagrams in Section 8.0.
S Push any excess wire into the wall. Seal hole in wall to prevent any air leaks.
Air leaking from b ehind the wall can affect measured temperature and
humidity, and can affect operation.
S Attach Infinity System Control to the mounting plastic by lining up the plastic
guides on the back of the control with the opening on the mounting plastic and
push on.
S Perform installation of all other system equipment (i.e. dampers, humidifier,
ventilator, UV lights, etc.). See the equipment and device installation
instructions for details.
S Turn on power to equipment.
To Next Page
Loading...
