Hydraulic manifold (option 325A):
The hydraulic manifold option is used to facilitate hydraulic connection of the two modules. It provides a single connection point for
the water inlet and outlet .
Two compensators are provided with the hydraulic manifold. They enable the two modules to be connected and absorb any installation
deviations. The customer must install these compensators when the two modules are installed.
Option 325A without 116V / W option
Option 325A with 116V / W option
Notes:
■ To allow the compensators to be installed, the position of the two modules and the distance between each module must
conform to the certied dimensional drawings.
■ The frost protection option (option 41D) provides thermal insulation for the hydraulic manifold water pipes and the frost
protection.
8 - WATER CONNECTIONS
45
To Next Page
Loading...
