Carrier AquaSnap Plus 30AWH008XB - Installation Procedures

5
30AWH
There is a pre-cut part that can be removed for running wires.
Do not remove the unit front panel for easier drilling of the
knockouts. The pre-cut section of the sheet can be removed
bypunchingthe3connectionpointsalongthelinerst
usingascrewdriverandnallywithyourhands(SeeFig.4).
Whenthecableknockoutisopen,removetheburrsandt
the cable protective bush supplied with the unit for cable
protection.
Installation
Before installation, check strength and horizontality of the
base so that abnormal sound does not generate.
According to the dimensions and clearances, x the base
rmlywiththeanchorbolts(Anchorbolt,nut:M10x2pairs).
Opening cable knockouts (Fig. 4)
How to remove the front panel (Fig. 5)
1.Removescrewsofthefrontpanel(Seeg.5). 2.Pullthefrontpaneldownwardwiththehandle.
Drain hose and base pan knockouts (Fig. 6)
Seeg.6.
In case of draining through the drain hose, attach the drain
nipple (A) and use the drain hose (Inner diam.: 16mm) sold
on the market. When there is a possibility of freezing of
drain at the cold district or a snowfall area, be careful for
drainage ability of drain.
The drainage ability increases when knockout holes on the
base pan are opened. (Open the knockout hole to outside
using a hammer (B), etc.).
Operating limits (Fig. 7/8)
Operation in cooling
Seeg.7
A- Outdoor air temperature (°C)
B- Outlet water temperature (°C)
Note: For the 30AWH004_ and 30AWH006_ units use
a minimum External Air Temperature of +5 °C.
( - -30AWH006_ ,-  -30AWH004_ )
Operation in heating
Seeg.8
A- Outdoor air temperature (°C)
B- Outlet water temperature (°C)
If the outdoor unit is installed in a very windy place, protect
the fan with a wind protection screen and check that it works
correctly.
English